- Pioneering 3d transfer plates by Railtec. See this superb example of a 3d plate & crest on Woody Bee's 7mm 33025.
-
Everything necessary to complete the loco (with the exception of cantrail lining - available separately if required).
-
Wonderfully sturdy print yet sufficiently thin to bed into those deep ribs.
-
Includes OHL flashes, data panels, bodyside instruction data, multiple working socket markings, lifting jack symbols and grilles.
-
Includes spares of everything - even the nameplate.
-
Nameplate and dedication plaque included on the same wafer-thin carrier for easy one-piece application.
- Deutsche Bahn AG is holder of the trademarks "DB" and "DB SCHENKER". The transfers are for private use only. The use of the transfers for commercial uses is not allowed and infringes the trademark rights of Deutsche Bahn AG.
- See the full 3mm range here.
- Many packs in other scales can be re-scaled to 3mm, if there is demand.
- Need the orange cantrail lining? Check out pack 4mm-1088.
- ONLY AT RAILTEC: Includes mounting screws in correct positions where applicable for that exquisite detail.
- ONLY AT RAILTEC: Correct radii of plate corners. The attention to detail sets a new standard.
- 3D printing process updated and enhanced August 2021 to give a superlative realistic finish.
- No more filing thin metal off a sprue! Pioneering 3D transfers give the correct raised detail and are preferred by many to etched.
- New technology allows you to move beyond outdated flat 2D transfers which cannot replicate any raised detail. Find out more about our unique 3D transfers here.
| Pete Waterman, OBE: |
|
"The 3D plates are so good I'm still speechless. This is the end of etched for cast plates." |
Tim Shackleton
Hornby Magazine: |
|
"3D transfers open up the world of finely detailed etched plates without any of the hassle and expense." |
|
